Installation; Positioning And Leveling; Electrical Connection; Connecting The Water And Electricity Supplies - Sunbeam Products Oster OS-DWG12SS Manual De Instrucciones

Keep this instruction manual in a safe place for future reference. If the appliance is sold, given
away or moved, please ensure the manual is kept with the machine, so that the new owner
may benefit from the advice contained within it.
Please read this instruction manual carefully: it contains important information regarding the
safe installation use and maintenance of the appliance.
If the appliance must be moved at any time, keep it in an upright position; if necessary, it may
be tilted onto its back.

Positioning and leveling

1. Remove the appliance from all packaging and check that it has not been damaged during
transportation. If it has been damaged, contact the retailer and do not proceed and further with
the installation process.
2. Check the dishwasher by placing it so that its sides or back panel are in contact with the
adjacent cabinets or even with the wall. This appliance can also be recessed under a single
worktop.
3. Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet of the
appliance may be adjusted until it reaches a horizontal position (the angle of inclination must
not exceed 2 degrees). If the appliance is levelled correctly, it will be more stable and much
less likely to move or cause vibrations and noise while it is operation.
Connection to the water and electricity supplies should only be performed by a qualified technician.
The dishwasher should not stand on top of the water hoses or the electricity supply cable.
The appliance must be connected to the water supply network using new piping. Do not use old
piping.

Electrical connection

Before inserting the plug into the electrical socket, make sure that: the socket is earthed and
complies with current regulations.
the socket can withstand the maximum load of the appliance, which is indicated on the data
plate located on the inside of the door (see description of the appliance).
the power supply voltage falls within the values indicated on the data plate on the inside of the
door.
the socket is compatible with the plug of the appliance. If this is not the case, ask an authorized
technician to replace the plug (see assistance); do not use extension cables or multiple sockets.

Connecting the water and electricity supplies

Connecting the water inlet hose

INSTALLATION

English-18