Installation Instructions; Before You Begin; Tools You Will Need; Electrical Requirements - Haier QHNG08AA Manual Del Usuario

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN

Read t hese inst ruct ions complet ely and carefully.
IMPORTANT –
•
for local inspect or's use.
IMPORTANT –
•
codes and ordinances.
• Not e t o Inst aller – Be sure t o leave t hese
inst ruct ions wit h t he Consumer.
• Not e t o Consumer – Keep t hese inst ruct ions for
fut ure reference.
• Skill level – Inst allat ion of t his appliance requires
basic mechanical skills.
• Complet ion t ime – Approximat ely 1 hour
• We recommend t hat t wo people inst all
t his product .
• Proper inst allat ion is t he responsibilit y
of t he inst aller.
• Product failure due t o improper inst allat ion is not
covered under t he Warrant y.
• You MUST use all supplied part s and use proper
inst allat ion procedures as described in t hese
inst ruct ions when inst alling t his air condit ioner.
ELECTRICAL
REQUIREMENTS
These models require a 115/ 120- volt AC, 60- Hz
grounded out let prot ect ed wit h a 15- amp
t ime- delay fuse or circuit breaker.
The 3- prong grounding plug minimizes t he
possibilit y of elect ric shock hazard. If t he wall out let
you plan t o use is only a 2- prong out let , it is your
responsibilit y t o have it replaced wit h a properly
grounded 3- prong wall out let .
CAUTION
Do not , under any circumst ances, cut or remove t he
t hird (ground) prong from t he power cord.
Do not change t he plug on t he power cord of t his air
condit ioner.
Aluminum house wiring may present special problems—
consult a qualified elect rician.
8
Save t hese inst ruct ions
Observe all governing
ELECTRICAL
REQUIREMENTS (cont )
Power cord includes a current int errupt er device. A t est
and reset but t on is provided on t he plug case. The device
should be t est ed on a periodic basis by first pressing t he
TEST RESET
int o t he out let . If t he TEST
t he RESET
use of t he air condit ioner and cont act a qualified service
t echnician.

TOOLS YOU WILL NEED

Phillips head screwdriver
Drill and 1/ 8" drill bit
Pencil
Level
Ruler or t ape measure
Scissors or knife
49- 5000537 Rev. 2