Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
► 1. Thin steel plate 2. Penetration amount into
concrete
CAUTION:
•
Use this tool only for soft concrete built up not
so long before. Using on the hard concrete may
cause nail bending or nail-driving to insufficient
depth.
•
When the penetration amount into concrete is
required more than 20 mm (13/16"), driving nails
to the sufficient length may not be obtained.
Nails may be driven too shallow causing unsta-
ble workpiece, resulting in personal injury and
damage to property.
Anti dry fire mechanism
This mechanism prevents the tool from firing without
nail.
Dry fire prevention automatically functions when the
rest of nails get to the last 2-3 pieces.
Jammed nailer
WARNING:
•
Always be sure to remove the fuel cell and the
battery cartridge before clearing a jam.
CAUTION:
•
Do not use deformed nails or nail strip. Failure
to do so causes poor nail feeding.
Follow the removing nail procedure and remove the
jammed nails.
► 1. Magazine
2
1
Remove the fuel cell, the battery cartridge and nails.
Loosen the bolt on the magazine. Remove the maga-
zine and remove the jammed nails.
If the nails cannot be removed after performing above
method, do as follows.
Insert a small rod or the like into the ejection port and
tap it with a hammer to drive out the jammed nails from
the ejection port.
► 1. Under driver guide 2. Bolt
If the nails still remain in the ejection port, do as follows.
Loosen the bolts on the ejecting port by using a hex
wrench. Remove the under driver guide. And remove
the jammed nails.
Return the under driver guide and tighten the bolts after
the jammed nails are removed.
Return the magazine and tighten the bolt.
10 ENGLISH
1
2
Publicidad
Tabla de contenido
