AL-KO CSM 1815 Instrucciones De Operación página 40

GB
Malfunction
Engine does not start.
Motor stops during operation.
Motor keeps cutting out.
The chain bar and saw chain be-
come hot when running. Smoke
development.
Motor running, but the saw
chain does not move.
Only sawdust is thrown out,
rather than wood chips. The
pruning saw must be forced
through the wood.
Appliance vibrates unusually.
Foldable chain cover is jammed. Appliance fault
Battery operating time drops
significantly.
Battery cannot be charged.
40
Cause
Battery is flat.
Battery missing or not insert-
ed correctly.
Power supply is interrupted.
Too much pressure exerted
on the pruning saw. The
overload protection has
switched off the device.
Battery is flat.
Battery is too hot.
Battery is defective.
The ON/OFF switch is defec-
tive.
The saw chain is too taut.
Oil tank is empty.
The oil entry hole and/or
groove of the chain bar are
dirty.
The saw chain is too taut.
Appliance fault
The saw chain is blunt.
Appliance fault
The service life of the battery
has expired.
Battery contacts are soiled.
Help in case of malfunction
Remedy
Charge the battery.
Install the battery correctly.
1. Remove the battery.
2. Clean the plug contacts.
3. Install the battery again.
Pull the pruning saw out of the
kerf and switch on again. Exert
less pressure during sawing.
Charge the battery.
Allow the battery to cool down.
Replace the battery.
Contact one of the manufactur-
er's service centres.
Check the chain tension. Reten-
sion the saw chain.
Refill with saw chain oil.
Clean the oil entry hole and
groove of the chain bar.
Check the chain tension. Reten-
sion the saw chain.
Contact one of the manufactur-
er's service centres.
Contact one of the manufactur-
er's service centres.
Contact one of the manufactur-
er's service centres.
Contact one of the manufactur-
er's service centres.
Replace the battery. Use only
genuine accessories from the
manufacturer.
Contact one of the manufactur-
er's service centres.
CSM 1815