Fuel Safety - Husqvarna 578BTF Manual De Usuario

for the address of your nearest service
agent.
To do a check of the muffler
WARNING:
a defective muffler.
WARNING:
hot during and after operation, also at idle
speed. Use protective gloves to prevent burn
injuries.
The muffler keeps noise levels to a minimum and sends
exhaust fumes away from the operator.
1. Stop the engine.
2. Do a visual check for damage and deformation.
Note:
The inner surfaces of the muffler contain
chemicals that can cause cancer. Be careful not to
touch these elements if the muffler is damaged.
3. Make sure that the muffler is correctly attached to
the product. Tighten the screws to 8-10 Nm.
4. Examine the spark arrester screen, do a visual
check.
a) Replace the spark arrester screen if it is
damaged.
b) Clean the spark arrester screen if it is blocked.
To do maintenance of the muffler on
Refer to
page 13 for more information.
Vibration damping system
The product has a vibration damping system that
decreases vibrations and makes operation easier.
Examine the vibration damping system and make sure
1913 - 001 - 16.08.2022
Do not use a product with
The muffler becomes very
that it is not damaged. Make sure that the vibration
damping system is attached correctly.
Air filter
Do not use the product without an air filter or if the air
filter is damaged or has a deformation.
Stop switch
Use the stop switch to stop the engine. Make sure that
the engine stops fully.
Harness safety
Always use the harness when you operate the product.
If you do not use the harness, you cannot operate the
product safely. This can result in injury to you or other
persons. Make sure that the harness are attached and
correctly adjusted.

Fuel safety

WARNING:
instructions that follow before you use the
product.
• Do not mix the fuel indoor or near a heat source.
• Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and
x2
Read the warning
7