Adjusting The Carburetor; Replacing The Engine Oil - EcoFlow Smart Generator Dual Fuel Manual Del Usuario

3.2 Adjusting the Carburetor

The carburetor is an important part of engine, and should be adjusted by the dealer who has the
professional knowledge, data and equipment to ensure it is adjusted correctly.

3.3 Replacing the Engine Oil

Do not drain the engine oil immediately after the generator is switched off. The oil
Warning
temperature will be very high. Please take care not to get scalded when draining the oil.
1. Place the generator on a level plane, start it up and keep it running for several minutes to increase
its temperature. Then turn it off. Turn the Engine Switch and the fuel cap breather knob to "OFF".
2. Turn the maintain cover knob to
3. Unscrew the lid and oil dipstick.
4. Place the oil basin under the generator and tilt the generator. The oil will drain quickly.
Tips: Improper disposal of engine oil may harm the environment. If you replace the engine oil yourself,
please dispose of the used oil properly. Store the used oil in a sealed container and take it to your
nearest oil recycling center. Do not pour it into any trash can, onto the ground or into the sewer.
5. Place the generator in its original horizontal state.
Do not tilt the generator when adding engine oil to prevent damage to the generator due to
Caution
adding excessive oil.
6. Refill the oil to the proper level.
7. Wipe the oil dipstick clean and remove any spilled oil.
Warning
Prevent any foreign objects from entering the inside of the engine.
8. Tighten the oil dipstick and lid.
9. Reinstall the maintenance cover and turn the knob to Closed.
18
and take off the maintenance cover.