Würth ARS 10-1/4 Manual De Instrucciones página 16

3. When you charge a new battery pack or a battery
pack which has not been used for a long period, it may
not accept a full charge. This is a normal condition and
does not indicate a problem. You can recharge the
battery pack fully after discharging it completely a couple
of times.
4. If you wish to charge two battery packs, allow 15
minutes between charging on the fast charger.
5. Plug the fast charger into you source. Insert battery
pack so that the plus and minus terminals on the battery
pack are in the same slides as their respective markings
on the fast charger.
6. The charging light will come on and charging will
begin. If the charging light go out soon, remove the
battery pack from the charger and let it cool off for more
than one minute. Then reinsert it and try to charge it once
more.
7. If the charging light goes out within one minute even
after repeating this procedure a couple of times, the
battery pack is dead. Replace it with a new one. When
the charging light goes out after about one hour, you may
remove the fully charged battery pack.
8. After charging, unplug the charger from the power
source.
The LED Light On The Charger
Power On
(Green light flashes slowly)
Battery Low
(Red light stays illuminated)
Battery charged 80%
(Green light flashes rapidly)
Battery charged 100%
(Green light stays illuminated)
Battery Pack temperature is too hot
or too cold (Red light flashes slowly)
Battery Pack malfunction
(Red and Green lights stay illuminated)
16
WARNING
1. Charger is plugged into a 100-240V a.c
outlet only.
2. If the battery pack is too hot or too cold,
the charger will not fast charge the battery
pack and the red Indicator light is "blinking". When the
battery pack temperature returns to between 08C(328F)
and 508C(1228F), The charger will automatically begin
charging.
3. If both red and green indicator lights are "ON" the
battery pack either does not comply or is defective.
Please contact your retailer.
4. Do not charge the battery pack in the rain, snow or
high temperature environment.
5. Do not charge battery pack when environment tempe-
rature is below 08C(328F)or above 408C(1048F)
6. While charge the cool battery pack (below 08C) in
the warm indoor, keep the battery pack in the room for
one hour to warm up before starting the battery pack.
A cool battery may charge unsaturated.
7. Remove the plug after finishing the charge.
8. The charger should be cooled at least one hour after
continue charging three times.
9. Do not use generator for charging the battery pack.
SPECIFICATIONS
Art. No 0700 314 X
Voltage 10.8V d.c.
No-Load 220 l/min (r.p.m.) 180 l/min (r.p.m.)
Speed
Max. Torque 350kg-cm/
34.3N.m / 25ft-lb
Anvil Size 1 / 4"
Charging 60-70 Minutes Hour Auto Cut-Off
Time
Weight (Battery 0.185kg)
(With 0.91 kg
Battery)
0700 312 X
630kg-cm /61.7N.m/
45ft-lb
1 / 2"
1.33 kg