Slide - Sauder Tremont Row 427968 Manual De Instrucciones

Step 2
å
Separate the NARROW EXTENSION SLIDES (2) from the NARROW EXTENSION RAILS (1) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the NARROW EXTENSION RAILS (1) to the ENDS (C and D). Use six 1/2" FLAT HEAD SCREWS (21) through
the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
inner cartridge of the EXTENSION RAIL in to find the other two holes that line up with the holes in the END. Turn a
SCREW into each of these holes..
å
NOTE: The NARROW EXTENSION SLIDES will be used later for the SMALL DRAWER.
Slide the black lever, and pull the SLIDE from the RAIL.
427968
2
1
st
D
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the
st
1/2" FLAT HEAD SCREW
(6 used in this step)
1
1
Edge with
HIDDEN CAMS
The CAM SCREW
must be here.
7
21
1
st
1
C
Open end
Page 7