Sauder Tremont Row 427968 Manual De Instrucciones página 8

Step 3
å
Separate the WIDE EXTENSION SLIDES (4) from the WIDE EXTENSION RAILS (3) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (3) to the ENDS (C and D). Use six 1/2" FLAT HEAD SCREWS (21) through
the exact holes shown.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
inner cartridge of the EXTENSION RAIL in to find the other two holes that line up with the holes in the END. Turn a
SCREW into each of these holes.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWER.
Slide the black lever, and pull the SLIDE from the RAIL.
Page 8
4
1
st
3
D
www.sauder.com/service
hole shown in the enlarged diagram. Then, slide the
st
1/2" FLAT HEAD SCREW
(6 used in this step)
3
C
7
21
1
st
3
Open end
427968