STEINEL XLED Manual Del Usuario página 10

Installation
The site of installation should be at least 50 cm away
from another light because heat radiated from this
may activate the system. To obtain the specified
max. reach of 8 m, the sensor should be installed at
a height of approx. 2.2 m. Install the unit on a firm
surface to avoid unintentional triggering.
The mains supply lead is a 3-core cable.
L = phase conductor (usually black or brown)
N = neutral conductor (usually blue)
PE = protective-earth conductor (green/yellow)
Functions -
h i
Switch-off delay
(time setting) h
(factory setting: 2 s)
Twilight setting
(response threshold) i
(factory setting:
daylight mode 1000 lux)
Reach setting/adjustment
The detection zone setting can be adjusted to suit
requirements.
All manuals and user guides at all-guides.com
2 s – 70 min
2 – 1000 Lux
j
Important: Connecting the conductors to the wrong
terminals will produce a short circuit in the unit or your
fuse box at a later stage when you come to switch the
power on. In this case, you must identify the individual
cables and re-connect them. A suitable mains switch
for switching the light ON and OFF can be installed in
the mains lead.
Hinweis: Die Lichtquelle dieser Leuchte ist nicht
ersetzbar, falls die Lichtquelle ersetzt werden muss
(z.B. am Ende Ihrer Lebensdauer), ist die komplette
Leuchte zu ersetzen.
Control dial set to min = shortest time (2 s)
Control dial set to max = longest time (70 min.)
When setting the detection zone,
we recommend selecting the shortest time.
The sensor's response threshold can be infinitely
varied from 2 – 1000 lux.
Control dial set to daylight operation =
approx. 1000 lux.
Control dial set to twilight operation = approx. 2 lux.
To adjust the detection zone in daylight, the control
dial must be set to (daylight operation).
a) By swivelling the floodlight head through +/- 30°
b) By using adhesive shrouds, e.g. to mask out paths
or neighbouring property.
- 9 -