FLAEM RF9 Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
method A: sanitise accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4 un-
der potable hot water (approximately 40 °C) with a gentle, non abrasive dish detergent.
method B: sanitise accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4 in
the dishwasher with a hot cycle.
method C: sanitise accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4 by
immersing them in a solution of 50% water and 50% white vinegar, then rinse thoroughly
under potable hot water (approximately 40 °C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION
paragraph.
After having sanitised the accessories, shake them vigorously and place them on a paper
towel. Alternatively, dry them with a jet of hot air (for example, a hair dryer).
DISINFECTION
After sanitising the nebuliser cup and the accessories, disinfect them choosing one of the
methods described below.
method A: Accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4 can be dis-
infected.
The disinfectant must be an electrolytic chloroxidizer (active principle: sodium hypochlo-
rite) specific for disinfecting, which is available in any pharmacy.
Implementation:
- Fill a container big enough to hold all of the parts to disinfect with a solution of potable
water and disinfectant, according to the proportions indicated on the packaging of the
disinfectant.
- Completely immerse each part in the solution, taking care to avoid the formation of air
bubbles on the parts. Leave the parts immersed for the amount of time indicated on the
packaging of the disinfectant associated with the concentration chosen for the solution.
- Remove the disinfected parts and rinse abundantly with warm potable water.
- Dispose of the solution following the instructions provided by the disinfectant manufac-
turer.
method B: sanitise the accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4
by boiling them in water for 10 minutes; use demineralised or distilled water to prevent
calcium deposits.
method C: sanitise the accessories 1-2-3-4-5-6-8-9-11.1a-11.1b-11.1c-11.2-11.3-11.4
with a hot steam steriliser for baby-bottle (not the microwave type). Perform the process
faithfully following the instructions of the steriliser. To ensure that the disinfection is effec-
tive, choose a steriliser with an operating cycle of at least 6 minutes.
After having disinfected the accessories, shake them vigorously and place them on a pa-
per towel. Alternatively, dry them with a jet of hot air (for example, from a hair dryer).
At the end of each use store the device complete with accessories in a dry place away
from dust.
For the CLEANING SANITISATION DISINFECTION of accessories 7 follow the instructions
in the instruction manual.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido