To Examine The Cutting Equipment; To Do A Check Of The Guide Bar; User Interface; Battery - Husqvarna 240i Manual De Usuario

To examine the cutting equipment

1. Make sure that there are no cracks in rivets and
links and that no rivets are loose. Replace if it is
necessary. (Fig. 148)
2. Make sure that the saw chain is easy to bend.
Replace the saw chain if it is rigid.
3. Compare the saw chain with a new saw chain to
examine if the rivets and links are worn.
4. Replace the saw chain when the longest part of the
cutting tooth is less than 4 mm/0.16 in. Also replace
the saw chain if there are cracks on the cutters. (Fig.
149)

To do a check of the guide bar

1. Make sure that the oil channel is not blocked. Clean
if it is necessary. (Fig. 144)

User interface

LED screen Possible faults
The warning in- Chain brake is
dicator flashes. engaged.
Temperature
deviation.
Overload. The
saw chain can
not move.
The power trig-
ger and the
start/stop but-
ton are pushed
at the same
time.
Green activate Low battery
LED flashing. voltage.
The warning in- Service.
dicator is on.

Battery

LED display
Green LED flashes.
38
2. Examine if there are burrs on the edges of the guide
bar. Remove the burrs using a file. (Fig. 150)
3. Clean the groove in the guide bar. (Fig. 145)
4. Examine the groove in the guide bar for wear.
Replace the guide bar if it is necessary. (Fig. 151)
5. Examine if the guide bar tip is rough or very worn.
(Fig. 152)
6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary. (Fig.
146)
7. Turn the guide bar daily to extend its life cycle. (Fig.
153)

Troubleshooting

Possible solution
Disengage the chain brake.
Let the product to cool down.
Release the saw chain.
Release the power trigger to activate the product.
Charge the battery.
Speak to your servicing dealer.
Possible faults
Low battery voltage.
Possible solution
Charge the battery.
1951 - 001 - 23.09.2022