GYS KRONOS 400T G Manual De Uso página 20

User manual
CONNECTING OF THE INTERCONNECTION CABLE
Make sure the main welding power source switched off when connecting or disconnecting the wire feeder. Ensure the machine is
unplugged from the mains, and then wait 2 minutes.
For details of the wiring harness connection between the generator and the wire feeder, please refer to the separate wire feeder manual (optional).
The diagrams below describe the minimum requirements for the various different welding processes. The user can leave any unused connections (gas
connection in MMA welding, power cable on the wire feeder in MMA and TIG welding, etc.) if they wish.
MIG-MAG welding (positive polarity)
20
Translation of the original
instructions
400T G
KRONOS 400T G / 400T GW
400T GW