Assembly And Operation - Bestway 58623 Manual Del Propietário

Assembly and Operation

WARNING For Charging
• Use only the original external adaptor and provided charging cable.
• Make sure the robot and the charger port are clean and dry before set-up.
• Make sure that the robot is turned off by sliding the switch to OFF position prior to charging.
• Fully charge the robot (about 5-6 hrs) before using it for the first time
• Power indicator light: No light - Power off / no power
Light - Power on
Blinking light - Battery power will cease within 10 minutes.
Note:
Once the robot begins charging, the indicator light on the external adaptor will turn red. When the robot is almost fully charged, the indicator light will turn green.
1
4
6
7
Note:
Pry to detach the float cover and release the rope from the float to the depth of pool water plus about 0.5 m (19.7 in.).
2
OFF
5
1.
1
2
3
1
For pools where the If the robot does not cover the
entire pool with either pin position
shortest length is
1 or 3, try this setting. If the situation
3 meters or above
persists, deploy the robot from a
different location.
2. 3.
6
3
5-6 h
RED light – Charging
GREEN light - Charged
2 3
For pools where the
shortest length is 3
meters or below.
(Factory setting)
4.