Brandson Equipment 305883 Manual De Instrucciones página 28

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5. Installation
Take the appliance out of the package and remove all the packaging material. Then
check the product for any damage. Choose a suitable socket and connect the fan
heater to it. The place of installation of the heater should be at least 1 meter away
from other objects and the ground.
Caution! Make sure that the appliance is not placed near flammable materials or
any liquids. The air outlet should also not point in this direction.
Note: To ensure that the heater works and heats properly, the desired temper-
ature must be set on the heater so that it is a couple of degrees higher than the
room temperature. If the heater does not start heating, increase the desired
temperature on the appliance to activate the heating elements.
6. Initial use
Connect the appliance to a 220-240 V AC socket. Set the ON/OFF switch at the side
of the appliance to position "I" to start the fan heater. The heater then shows the
current temperature in the display. To switch off the appliance, set the "ON/OFF"
switch to "0".
Press the "
" button on the control panel at the front of the fan. The ventilation
starts now.
You can adjust the desired room temperature using the "Temp +" (remote control=
) and "Temp -"(remote control=
) temperature buttons. The fan heater now
heats until the specified room temperature is reached.
Note: The fan heater is connected to a timer. Wait for 60 seconds after switching
the appliance off before disconnecting it from the socket.
Thermostat function
Press the temperature buttons "Temp +" (Remote control=
) and "Temp -" (Re-
mote control=
) to set the desired temperature. Temperatures between 15°C
and 30°C can be set. If the set temperature is less than or equal to the current air
temperature, the heating function is switched off. The fan does not switch off and
maintains the set temperature.
When the set temperature is higher than the current air temperature, the appli-
ance switches on again and heats until the desired room temperature is reached.
28
English

Publicidad

Tabla de contenido
loading

Tabla de contenido