Descargar Imprimir esta página

Brandson Equipment 305883 Manual De Instrucciones página 29

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Timer function
Press the "
" button to switch on the timer. Every time you press the timer but-
ton, the value increments by one hour, up to a maximum of 12 hours. Press the
timer button again to reset the timer. The time duration set is shown in the display.
As soon as the timer is set, the countdown function starts counting down and
switches off the appliance at the end of the timer count.
7. Speed levels
The fan heater has 2 speed levels. You can change them by pressing the "Temp
+" and "Temp -" buttons simultaneously on the control elements of the fan. You
can make the same setting with the remote control using the "Change fan speed"
button. The current speed level is briefly shown on the display.
"LL" = Speed level 1 (Low)
"HH" = Speed level 2 (High)
8. Overheating
Overheating generally occurs only if one of the openings of the fan heater is
blocked. This appliance comes with a self-resetting thermal fuse. The heater
switches off automatically once the overheating temperature is reached. The fan
heater can be operated again once the fuse is reset.
9. Cleaning and Care
Completely switch off the appliance and disconnect it from the power supply be-
fore you start cleaning it. Clean the housing with a slightly damp cloth, a vacuum
cleaner or a dusting brush. Never use flammable, aggressive or scouring cleaning
agents such as benzene or spirit to clean. Clean the air inlet and outlet regularly
using a vacuum cleaner. If the appliance is not going to be used for a long time,
then it must be protected against excessive dust and dirt.
10. Safety instructions and disclaimer
Never try to open the appliance to repair or make modifications. Avoid contact
with the mains voltage. Do not short-circuit the product. The device is not ap-
proved for outdoor use. Therefore please use it only in dry surroundings. Protect
it from high humidity, water and snow. Keep the product away from high temper-
atures. Do not expose the product to sudden changes in temperature or strong
vibrations, as this could damage the electronic components.
29
English

Publicidad

loading