List Of Parts - Cosatto cabi Manual De Instrucciones

list of parts

1
1. Car seat 2. Hood 3. Pad set 4. Car seat liner 5. Car seat adapters x 2 (Adaptors for use
with the Mobi 3 in 1 combi ONLY)
A. Handle B. Handle adjustment button C. Receiver for pushchair adaptor D. Belt guide
positioning the car seat in the car
2
IMPORTANT: NEVER USE AN INFANT CARRIER ON A SEAT WHERE AN AIRBAG IS FITTED. THE
SEAT MUST ALWAYS BE FITTED, REARWARD FACING.
securing your child seat (rearward facing)
3
1. Place the handle (A) in position one (see Changing the handle position).
2. Pass the waist strap of the car safety belt through the front strap guide (1) and secure.
3. Pass the car seat diagonal belt through the guide on the back of the car seat (3). Note. The
strap goes under the handle (2).
4. Tighten, pulling the diagonal car seatbelt that normally travels across the passengers chest and
finally securing. Ensure that the child car seat is secure with the handle resting against the motor
car seat back.
adjusting the harness as your child grows
4
1. These can be adjusted (2 positions) when required to suit a growing child.
2. To change the position of the straps you will need to open the adjustment compartment (A) by
pushing in the release catch and pulling outward.
3. Release straps from distribution plate (B). If adjusting shoulder strap height, ensure webbing is
always attached to the distribution plate.
4. The shoulder straps must be threaded through the slots in the back of the car seat so that they
are level with the child's shoulders.
5. Re-secure to distribution plate (B)
general harness adjustment
5
1. It is recommended to adjust the harness length to fit your child, before installing the child seat
into the car.
2. To tighten the shoulder straps, pull the webbing at the end of the TMS system until achieving
the fit and tension required.
3. To loosen off the shoulder straps push inwards the TMS release catch and pull forward the
shoulder straps with the other hand keeping the TMS catch pushed down. Releasing the catch
will secure the harness in place.
NOTE: The harness must be reasonably tight. It should restrain but not make the child
uncomfortable.
4. Check that the straps are not twisted while the child is seated.
fastening harness buckle
6
Fit the two shoulder strap buckle parts together and push into the crotch fitting until a firm click
is heard. To open press the RED button.
changing the handle position
7
The handle can be placed in 4 different positions:
1. Fitted in the car position
3. Rocker position.
To change positions, push the buttons on either side of the handle and move the handle rearward
or forward.
All manuals and user guides at all-guides.com
2. Carrying position
4. Steady position