List Of Parts - Cosatto HOLD Manual De Instrucciones

operation:

1 - list of parts

1. Child car seat base
a. Anti rebound bar
b. Storage compartment for instructions
c. Vehicle seat belt lock
2 - fitting the child car seat base - 1
Place the child car seat base on the vehicle seat with the anti-rebound bar against the
vehicle seat backrest (a).
Release the vehicle seat belt lock catch (b) and lift up the vehicle seat belt lock (c).
Noting the location of the vehicle seat belt guide (d), feed the vehicle seat belt through
the slot in the side of the child car seat base, under the vehicle seat lock (e) and through
the slot in the other side of the base. The vehicle seat belt should be located under the
vehicle seat belt guide on each side of the child car seat base.
Ensure the vehicle seat belt is sitting on top of the raised section under the vehicle seat
belt lock (f).
Fasten the vehicle seat belt (g).
3 - fitting the child car seat base - 2
Pull back on the vehicle seat belt to tension the belt (a).
Close the vehicle seat belt lock (b) and fasten the vehicle seat belt lock catch (c). Push
down on the vehicle seat belt lock catch (d) until a click is heard and the vehicle seat belt
lock is secure.
IMPORTANT: The position of the seat belt/lap strap buckle can affect the stability of the
child car seat base. In an accident this could stop the child car seat from protecting your
child as well as it should. If, when the seat belt/lap strap belt is properly tightened, the
buckle lies in the position marked
seating position in your vehicle.
Press the button on the support leg foot (e) and adjust the height of the leg (f) until the
support leg foot is firmly on the vehicle floor. Do not place the support leg on a floor
storage compartment lid. The support leg MUST make full contact with the vehicle floor.
4 - fitting the child car seat to the child car seat base
With the child car seat handle in the carrying position place the child car seat, rearward
facing, on the child car seat base. The sides of the child car seat fit into the slots on
either side of the child car seat base (a & b).
Push down on the child car seat until the two securing rods are engaged (c).
Lift the car seat slightly to ensure all locks are engaged.
5 - removing the child car seat from the child car seat base
Ensure the child car seat handle is in the carrying position
Lift the release lever (a) and simultaneously lift the child car seat off the child car seat base (b).
d. Child car seat release lever
e. Adjustable support leg
f. Vehicle seat belt guide
then try fitting the child car seat base in another