Lapierre sit and go! Manual De Utilización página 50

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

III—Startandgo !
Power-assist bike
Storage
If the bicycle is not used for some time, make sure to:
— Carefully clean the bicycle before storage.
— Lubricate the chain, hub and other movable parts.
— Treat all chrome plated parts and galvanized parts with anti-
corrosive agent.
— If possible, store your bicycle hanging from a wall. If not
possible, the air pressure in tires should be checked at regular
intervals. Storage of a flat tire may result in prolonged damage.
— Charge your battery pack every two months. This is a critical
action that needs to be performed by the end-user. Failure to do
so could damage the battery pack.
Warning !
Please always use the assigned charger to charge the startandgo !
battery. Using a different charger with the startandgo ! battery could
result in damage to the battery itself, and possible dangerous conditions.
Warranty is invalid if incorrect charger is applied to cause malfunction.
Lapierre
reserves the rights to wave warranty upon inappropriate
operation in charging process.
Do not attempt to disassemble or alter any part of the startandgo ! battery
or battery charger.
Do not operate the startandgo ! battery outside the temperature range
from 0°C to 40°C / 32°F — 104°F.
All manuals and user guides at all-guides.com
Do not store the startandgo ! battery over the temperature range from
-20°C to 60°C /-4°F — 140°F to prevent damage. If the battery is stored
in this temperature range for a prolonged period of time, the battery life
could be greatly shortened.
Do not contact the battery with water or other liquid. Warranty is invalid
if water or any liquid gets into the startandgo ! battery, disconnect the
device immediately to avoid possible explosion or electrical shock.
Do not expose the startandgo ! battery to direct flame or heat ; or place it
near to flame or heat as the battery may explode.
Maintain good ventilation while charging.
Remove the battery packs after the batteries are fully charged.
Do not use the startandgo ! charger to charge Ni-Cd or Ni-Mh battery packs.
We strongly recommend not charging thestartandgo ! batteries
overnight or overtime without supervision.
Declaration
1 Lapierre
malfunctions resulting from the improper operation of the battery
or charger.
2 Please follow local regulations when attempting to dispose of any
battery product.
Recharge the battery at least once every second month
regardless the usage.
will hold no responsibility to any accidents or
51
GB

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Start and go!

Tabla de contenido