Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna DM 406 H Manual De Instrucciones

Ocultar thumbs Ver también para DM 406 H:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before starting

Ensure you stand firmly. Keep people and animals well
away from the working area.
Check that all couplings, connections and hydraulic hoses
are in full working order.
Make sure that:
The machine and its equipment are correctly installed.
The stand is properly fixed and that the drill is properly
mounted on the stand.
The drill is secured properly.
Water cooling is undamaged and connected to the
machine.
Use suitable drill bits depending on whether water or dry
drilling is being performed. In the event of uncertainty
contact your dealer, your service workshop or an
experienced operator.

Starting

NOTICE! Changing mechanical gear may only be done
when the machine is switched off. Otherwise there is a risk
of damaging the gearbox.
Set the control for the hydraulic motor speed to position I.
Turn on the water cooling.
Start the rotation by turning the rotation control to ON (I).
Carefully feed the drill bit in to obtain a good guidance.

Stopping

WARNING! The drill bit continues to rotate
!
for a while after the motor has been switched
off.
Do not stop the drill bit with your hands.
Personal injuries can occur.
Stop the rotation by setting the rotation control to OFF (0).
Allow the motor to stop completely.
Shut down the hydraulic unit.
10 –
English

STARTING AND STOPPING

Publicidad

Tabla de contenido
loading

Tabla de contenido