Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna DM 230 Manual De Instrucciones

Before starting

WARNING! Note the following before
!

starting:

The machine should be connected to an
earthed outlet socket.
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Ensure you stand firmly. Keep people
and animals well away from the working
area.
Make sure that:
• The switch is undamaged. If not, the switch must be
replaced by an authorised repairman.
• The switch is not sticking.
• The machine and its equipment are correctly installed:
- The drill is secured properly.
- If a stand is used, it must be attached to the machine
by the fastening neck on the gearbox.
• Wear personal protective equipment. See instructions
under the heading "Personal protective equipment".
• The water cooling or vacuum cleaner (with the help of
adapter) are attached to the machine. Use suitable
drill bits depending on whether water or dry drilling is
being performed. In the event of uncertainty contact
your dealer, your service workshop or an experienced
operator.
Starting
IMPORTANT! Changing gear may only be done when
the machine is switched off. Otherwise there is a risk of
damaging the gearbox.
1 Set the working speed by turning the drill spindle and
at the same time move the gear knob to the required
position.
12 – English

STARTING AND STOPPING

2 Turn on the water cooling (wet drilling) or switch on the
vacuum cleaner (dry drilling).
3 Hold the machine steady.
4 Press in the switch fully. Also press, if desired, the
TM
Smartstart button.

Stopping

WARNING! The drill bit continues to
!
rotate for a while after the motor has
been switched off. Do not stop the drill
bit with your hands. Personal injuries
can occur.
Stop the motor by releasing the power switch.
Cooling
Run the machine unloaded for a minute or two to cool the
motor.