Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna DM 220 Manual De Instrucciones

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
• Check that the machine is assembled correctly and do not
show any signs of damage. See instructions in the section
"Assembling and adjustments".
• Perform daily maintenance. See instructions in the section
"Maintenance".

Starting

NOTICE! Changing gear may only be done when the
machine is switched off. Otherwise there is a risk of
damaging the gearbox.
• Set the working speed by turning the drill spindle and at
the same time move the gear knob to the required
position.
• Turn on the water cooling (wet drilling) or switch on the
vacuum cleaner (dry drilling).
• Press down the power switch halfway to activate Smart
Start and all the way for full drilling speed.

STARTING AND STOPPING

Stopping

CAUTION! The drill bit continues to rotate for
!
a while after the motor has been switched
off. Make sure that the drill bit can rotate
freely until it is completely stopped.
Carelessness can result in serious personal
injury.
• Run the machine unloaded for a minute or two to cool the
motor.
• Stop the motor by releasing the power switch.
– 13
English