BH FITNESS G6400 Instrucciones De Montaje Y Utilización página 19

Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box.
Make sure that all of the pieces are
there, Fig.0: (1) Main structure; (74)
Safety key; (54) Bottle holder; (96)
Adapter; (S) Bottle of lubricant; (90)
Screw M4x8; Wrenches.
Follow the instructions step by step to
assemble:
1 Place the unit on the floor, Fig.1.
2 Loosen the L-shaped knobs (53) at
the bottom of the upright tubes by
turning them counterclockwise, Fig.2.
Lift the upright tubes to the vertical
position and retighten the L-shaped
knobs (53) by turning them clockwise.
3 Loosen the knobs (52) of the upper
part of the upright tubes, Fig.3, lift the
handlebar and retighten the knobs (52)
to fix the position.
4 Lift the monitor to the desired
position, Fig.4. Place the bottle holder
(54) on the left upright post using the
screws (90), Fig.4.
5 LUBRICATION.-
CAUTION: Before the first use, apply
approximately half the bottle of
Fig.B
lubricant in the central part of the
belt, along the entire board, and on
both sides as shown in Fig.7.
An illustrative video about lubrication is
available on BH Youtube channel:
https://www.youtube.com/c/BHFitnessS
ervice/videos.
Important notes:

If the bottle of lubricant is missing in
the box, please ask for it before
using an inappropriate lubricant.

Pay special attention to lubricate the
area where you place your feet
during the exercise.

After lubrication, start a program
without anybody using the machine
so that the belt moves and lubricates
properly. If you lubricate after
exercise (the belt and the band still
warm), the lubrication will be even
better.

Once the lubricant has been applied
you should neither fold nor use the
machine for a few hours. This will
allow the
impregnated.

If the belt starts to slip after
lubrication, then check the tension
of the belt. To tension the belt, take
the 6mm Allen key and with the
machine set to 4km/h turn screws
(R & L) one turn in a clockwise
direction.
ATTENTION:
responsibility to periodically check
the lubrication level of the belt. To
do this, unplug the treadmill from
the electrical outlet; place one hand
between the belt and the surface of
the board to ensure that both
surfaces are lubricated, especially
19
belt to get
It is the user's
well