Publicidad
Idiomas disponibles
Idiomas disponibles
in the area where you place your feet
during the exercise.
Please
note
maintenance
unsuitable products may lead to loss
of warranty.
Lubrication frequency:
For
optimal
recommends the use of it´s own
brand silicone-based lubricant.
As
a
general
recommends lubricating the belt at
least once a month or approximately
every 30 hours of use (whichever
happens first).
Use in very dry, hot or dusty
environments, by heavy people
and/or walking regularly at a slow
pace (<5km / h) increase the need
for lubrication. Depending on the
case, it may be necessary to
lubricate every fifteen days or even
every week.
Using another brand lubricant or
another type of lubricant may require
more frequent lubrication, and may
even damage the belt and/or the
board and cause motor and other
parts failure.
6 ADJUSTING THE BELT.-
CAUTION:
Before
machine, turn it on and check that
the belt is centered. If necessary,
follow the steps below.
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt, set
that
insufficient
or
the
use
maintenance,
guideline,
using
the unit in motion at a speed of 4km/h. If
the belt has moved to the right, turn screw
(R) on the right-hand side of the machine
a 1 4 turn clockwise. Note the position of
of
the belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn the
right
screw
BH
anticlockwise direction. Fig.8.
As soon as you have adjusted the belt
you can begin exercising again.
BH
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1 4 turn clockwise.
Note the position of the belt, if after one
minute the belt is not completely centred
then repeat the operation.
If you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction. Fig.8.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt itself.
Bear In mind that one turn of the right
screw (R) in a clockwise direction has
the same effect on the position of the
belt as one turn of the left screw (L) in
an
the
Consequently, in the event of excessive
belt movement you can use either of the
two
screws
overtightening the belt.
FOLDING YOUR UNIT.-
This treadmill is equipped with a folding
mechanism for storage purposes. To
use it, stop the treadmill and unplug the
mains cable.
Lower the monitor so that it is parallel
with the handlebar and loosen the
20
back
slightly
anticlockwise
in
order
in
an
direction.
to
avoid
Publicidad
