Storage; Installation; Commissioning; Operation - Wega Mininova 2GR EMA Manual De Uso Y Mantenimiento

3. STORAGE

The machine is stored by the Manufacturer or Distributor.

4. INSTALLATION

The machine must only be installed by the Technician.
When the machine is being installed, the Technician
must replace the water in the hydraulic circuits.
The machine's support base must be perfectly flat,
not incline by more than 2° and have no
irregularities.
The electrical system must be equipped with a
suitable residual-current device in compliance with
current laws and safety regulations.

5. COMMISSIONING

The machine must only be commissioned by the Technician.

6. OPERATION

6.1 Safety precautions

Carefully read the instructions provided in chapter
"I. SAFETY PRECAUTION" on page 3.

6.2 Emissions

Vibrations
Under conditions of use that comply with the instructions for
correct use provided in this manual, any detected vibrations
do not give rise to dangerous situations.
Sound emissions
The noise level emitted by the machine is on average
lower than 70 dB; therefore, the use of personal protective
equipment to prevent hearing damage is not compulsory.
If the machine emits unusual noises, the manufacturer must
be notified.
Electromagnetic environment
The machine is designed to work properly in any industrial
electromagnetic environment, falling within the Emission and
Immunity limits provided by current standards.
User MANUAL

6.3 Turning the machine on and off

6.3.1 Hydraulic connection to the
internal tank (if fitted)
Only fill the tank with cold potable water. Do not
use other types of liquids or carbonated beverages.
Operating without water may damage the machine.
After long periods of machine inactivity, the water
in the internal tank must be replaced.
• Fill the tank with potable water.
• periodically check the level of water in the tank and refill
as required.
2
2 5
A
If the LEDs (A) are flashing: fill the tank with
drinking water.
Mininova
Q
31 148
of