Carbon Brushes; Disposal Information; Declaration Of Conformity - Flex DGE 8-32 Instrucciones De Funcionamiento Originales

DGE 8-32
Cleaning
WARNING!
Do not use water or liquid detergents.
If metals are work over a prolonged period,
conductive dust may become deposited
inside the housing. Impairment of the
protective insulation! Operate the power tool
via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly blow out the housing interior

and motor with dry compressed air.

Carbon brushes

The electric power tool features cut-off
carbon brushes.
When the cut-off carbon brushes reach their
wear limit, the electric power tool switches
off automatically.
NOTE!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the
carbon brushes can be seen sparking
through the rear air inlet apertures. If the
carbon brushes are sparking excessively,
switch off the electric power tool imme-
diately. Take your electric power tool to
a customer service centre authorised by
the manufacturer.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the motor housing. Non-
compliance will deem the guarantee
obligations of the manufacturer null and void.
Spare parts and accessories
Other accessories, in particular insertion
tools, can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 60745 in accordance with the regu-
lations of the directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
24.06.2022
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
23