KNF LABOPORT N96 Manual De Instrucciones página 76

Commissioning
Connected com-
ponents
Pump discharge 5. When using as a vacuum pump: Safely drain the pump
24
NOTICE
3. Connect the lines to the pneumatic inlet and outlet.
4. Only connect components to the pump that are designed
for the pneumatic data of the pump (see Chapter 4 Tech-
nical data [} 13]).
discharge at the pneumatic outlet of the pump.
NOTICE
NOTICE
6. Plug the appropriate plug insert into the power supply.
NOTICE
7. Connect the pump to the power supply.
Translation of Original Operating Instruction, KNF 323241-323242 06/22
Laboratory pump Laboport® N96
Self-sealing NPT threads are located
on the pump. When tightening the ac-
cessories, do not tighten them all the
way in order to avoid damaging the
threads and the pump.
Hose radii selected too small can affect
the stability of the pump.
Secure the pressure-side connections
with a fastener (e.g., hose/pipe clamp)
to prevent the hoses from slipping
down from the connection.
Only operate the pump with the sup-
plied SELV power supply.