Publicidad
ORE 2-125 EC / OSE 2-80 EC / ODE 2-100 EC
Symbols used in this manual
WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAU TION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
N OTE
Denotes application tips and important
information.
Symbols on the power tool
To reduce the risk of injury, read the
operating instructions!
Wear goggles!
Wear ear protection!
Wear mask!
Class II tool
Disposal information for the old
machine
For your safety
WARNING!
Before using the power tool, please read and
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
be a danger to life and limb of the user or a third
party, or the power tool or other property may be
damaged.
The sander may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
The sander is designed
– for commercial use in industry and trade,
– for sanding wood, plastic, paint, filler and
similar materials using the dry sanding
process,
– for use with Velcro sanding sheet and
accessories which are indicated in these
instructions or which are recommended by
the manufacturer.
When metal is being ground, flying sparks
occur. Ensure that nobody can be endangered
by flying sparks.
Safety Warnings For Sander
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries.
Keep all safety instructions and
other instructions in a safe place
for the future.
■ Hold the power tool by insulated
gripping surfaces, because the sanding
surface may contact its own cord. Cutting
a "live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock.
■ Attention Risk of fire! Avoid overheating
the material to be ground and the
grinder. Always empty the dust container
before taking breaks from work. Grinding
dust in the dust sack, microfilter, paper
sack (or in the filter sack or filter of the dust
extractor) may self-ignite under unfavourable
conditions, e.g. caused by flying sparks when
grinding metals. It is particularly hazardous
if the grinding dust is mixed with paint or
polyurethane residue or other chemical
substances and if the material is ground for a
long time until hot.
11
Publicidad
