Publicidad
Idiomas disponibles
Idiomas disponibles
4.1
Configuring the Machine, Entering Welding Parameters
After the machine was switched on, Display 1 shows on the
screen.
The machine will then automatically start the auto-test pro-
cess to check the sensors and the system clock and to deter-
mine the number of free welding reports. This test can be
bypassed by holding down the STOP/RESET key when Dis-
play 1 is showing.
If during the auto-test an error is detected, a "Sys-
tem Error" message shows. When this happens, the
system has to be disconnected immediately from the
Caution
power supply, the heating element, and the facing
tool. Contact the manufacturer to discuss check-up
and any repair.
Subsequent to a successful auto-test or after it was bypassed,
the machine first shows overview screens on the selected
kind of machine and welding standard, then Display 3.
Display 3 shows the data for the report of the next welding,
including time of day, date, report number, and joint num-
ber, along with, in the second-to-last line, the actual input
voltage and — if the cable of the heating element for butt
welding is connected — the actual and nominal heating ele-
ment temperature before and after the slash.
From Display 3, it is possible to access the configuration
menu, in which the default behavior of the welding ma-
chine can be configured. To access it, press the MENU key
and then, on the following screen, enter the access code us-
ing the cursor keys or hold the transponder card in front of
the RFID reader.
Pressing the ñ and ò cursor keys in the menu that appears
(Display 4), you can select a menu option, then access the se-
lected sub-menu by pressing the MENU key again.
In the Machine Data sub-menu, the type of machine (its des-
ignation and its cylinder section) to which the hydraulic,
control, and data logging/reporting unit is connected, has
to be defined (see the arrow symbol in Display 5, where a
basic machine chassis of 315 mm with a cylinder section of
3.89 cm² is being selected). This definition is preset ex works
and needs changing only when, exceptionally, the control
unit is connected to a different basic machine chassis. To
change it, select the proper machine type by pressing the ñ
or ò cursor keys and confirm by pressing the START/SET key.
If the wrong machine is selected in this menu, all
pressure computations that the machine makes
Important
14
EN
Weld Control 315 User's Manual
O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
********************
*
O.M.I.S.A.
*
WeldControl 2.0 *
********************
Display 1
Welding Standard
DVS
Display 2
Next welding
15:44:52
29.05.12
232V
135C/220C
Rep. No. 00072/00002
Display 3
CODE : 415311
Settings
-M-
>Reporting
-M-
Sensor Parameter-M-
Machine Data
-M-
Display 4
HST 200
3.16
HST 250
5.10
>HST 315
5.89
HST 355
6.60
Display 5
Version November 2022_1
*
Publicidad
