omisa WeldControl 315 Manual De Uso página 51

O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
RFID card and then confirm the new number by pressing the
START/SET key.
It is possible to select a previously saved commission number
instead of the one shown on the screen by pressing the ï
and ð cursor keys simultaneously. This causes a screen to
show in which you can scroll through the commission num-
bers in memory using the ï and ð keys, to select a number
and then confirm it by the START/SET key. This number will
be used for the next welding. To quit the scroll mode with-
out selecting a commission, press the STOP/RESET key.
4.2.3 Entering or Changing the Joint Number
From Display 3 or after the commission number was entered,
the system requests the input of the welding number, or
joint number, if it was enabled in the configuration menu.
The joint number, or welding number, is assigned with ref-
erence to the job/commission number. This means that it in-
crements by 1 for every welding operation performed in the
scope of the current commission (identified previously by
entering the appropriate job number). In the example in
Display 3, the next welding operation will be saved to weld-
ing report number 72 while the joint itself is joint number 2
of the current job/commission.
The first joint of a commission for which no joint has
been saved to memory so far, always receives no. 1.
If the memory already holds joints for a commission,
Info
the system finds the highest number of the joints
existing for that commission and uses this number
plus 1. The user is shown the number thus found on
the screen and can apply or change it. If the user
changes the joint number, it is his responsibility to
make sure that no number is assigned twice in one
commission. If a joint number appears twice in a
commission, this will not affect the welding process
and the logging of its data in any way. However, in
that commission two joints will not be distinguished
by a unique number.
If user inputs leave some joint numbers unused (for
instance, for a given commission no. 1, 2, 3, 5, 6, 9),
the gaps do not get filled, and the automatically
found number proposed for the next welding oper-
ation will still be the highest existing number plus 1
(that is, 10 in this example).
The joint number can also be entered after simultaneously
pressing the cursor keys ï and ð when Display 3 is showing
on the screen.
Version November 2022_1 Weld Control 315 User's Manual
19
EN