Publicidad
Idiomas disponibles
Idiomas disponibles
O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
5.5
Deleting Data from Memory
The report data in memory can be deleted only after all
welding reports were transferred, which is indicated by the
"Download completed" message. When the storage media
is unplugged, a "Delete Memory" message appears. If the
START/SET key is pressed at this point, a further confirma-
tion message "Delete Memory, sure?" is shown, which has
to be confirmed once again by pressing the START/SET key.
Then, the report data in memory are deleted.
5.6
Keeping Data in Memory
When the cable or storage media is unplugged, a "Delete
Memory" message is displayed. Press the STOP/RESET key to
keep the current report data in memory. The process can
then be repeated once again.
Make a habit of handling the internal storage as descri-
bed at the beginning of Sect. 5, to maintain data inte-
grity and avoid any inadvertent deletion of the reports
Important
in memory.
6
Service and Repair
As the product is used in applications that are sensitive to
safety considerations, having it serviced and repaired only
by trained, specialized staff is highly recommended. Thus,
constantly high standards of operation quality and safety
are maintained. Feel free to request information on our rec-
ommended service partner in your area at the address in
Sect. 7.
7
Service and Repair Contact
O.M.I.S.A. S r l
Via Verga 9/11
20845 Sovico (MB), Italy
Web: www.omisa.it
We reserve the right to change technical specifica-
tions of the product without prior notice.
Info
Version November 2022_1
Tel.: +39 039 23 23 028
E-mail: info@omisa.it
Weld Control 315 User's Manual
33
EN
Publicidad
