omisa WeldControl 315 Manual De Uso página 50

"Pipe Length on" means that the length of both pipes/com-
ponents has to be entered before every welding, "off,"
that this is not possible.
"Weather Conditions on" means that the weather has to be
selected in a list before every welding, "off," that this
is not possible.
"Installing Company on" means that the company that per-
forms the installation work has to be entered before ev-
ery welding, "off," that this is not possible.
"Print Tags – M – " means that by pressing the MENU key,
the user can access a sub-menu for starting to print (a)
label(s) with reference to a given welding operation, us-
ing the optional label tag printer.
All data that are available in the chip of a transpon-
der card can be entered by placing the card in front
of the RFID reader. If they are encoded in a bar code,
Info
they can be read using a handheld scanner.
4.2 Entering Preformatted and User-defined Traceability Data
When the system is used in the Weld Control mode, all trace-
ability data enabled in the configuration menu at "Record-
ing" (see Sect. 4.1.6) have to be entered before the welding
process. The welding system prompts the user to enter them
before the welding process proper. Depending on what da-
ta is entered, either its repeated input is mandatory (e. g.,
the welder ID code; see Sect. 4.2.1) or previously entered
data can be changed and confirmed or confirmed without
changes (e. g., the commission number; see Sect. 4.2.2).
4.2.1 Entering the Welder ID Code
When the welding is started by pressing the START/SET key
while Display 3 is showing, first the input of the welder iden-
tification code is requested, if it is enabled in the configura-
tion menu (see Display 11). The code has to be an ISO-com-
pliant code. It can be entered either using the cursor keys
and confirming the input by pressing the START/SET key, or
by reading a RFID transponder card or scanning it from a bar
code with the optional handheld scanner.
When the code was properly scanned or entered, this is con-
firmed by an audible signal.
4.2.2 Entering or Changing the Commission Number
From Display 3 or after the welder identification code was
entered, the machine requests the input of the job num-
ber, or commission number, of a maximum 32 characters, if
it was enabled in the configuration menu. If a commission
number exists already in memory, this one is proposed. You
can either confirm it by pressing START/SET or change it us-
ing the cursor keys or reading it with the scanner or from a
18
EN
Weld Control 315 User's Manual
O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 11
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 12
Version November 2022_1