Technical Data; Cutting Capacity; Cutting Head - Truper CEP-20 Instructivo

TECHNICAL DATA:

Power:
Frecuency:
Current:
Rated motor power:
No-load motor speed:
Cutterhead speed:
Power Cord Grips used in this product: Type "Y".
All conductors are: 12 AWG x 3 C with insulation temperature of 105 ºC
Tool Build Quality: Basic insulation
Insulation: Class I
Thermal insulation on motor winding: Class B
IMPORTANT NOTE: If the power cord is damaged, it must be replaced by the manufacturer or Truper
Service Center in order to avoid any risk of shock or major accident.
The construction of this product is designed so that its electrical insulation is impaired by splashing or spillage
of liquids during operation.
WARNING
WA RNING: Before gaining access to the terminals, all power circuits must be disconnected.
SPECIFICATIONS:

Cutting capacity:

Minimum allowable length:
Maximum material width:
Minimum material thickness:
Maximum material thickness: 8"
Maximum planing depth:
Forward speeds:
Speed 1: 5 m/min (16.4 fpm)
Speed 2: 6.3 m/min (20.6 fpm)

Cutting head:

Number of blades: 4
Diameter: 3 1/8"
Speed: 5 000 RPM
Feed Roller:
Table bed rollers (Two): Adjustable
Table: 20" x 25 3/4"
ADDITIONAL SAFETY RULES FOR THE PLANER
1. If you are not thoroughly familiar with planer operation, obtain advice from your supervisor, instructor,
or other person.
2. Keep the cutting head sharp and free of rust and resins.
3. Check material for loose knots, nails, and other defects.
4. Remove chips only with the tool turned off.
5. Keep your hands away from the top surface of the board when near the feed rollers.
6. Check that the switch is in the off position before plugging in the power cord.
7. Before moving the table up or down, loosen the locking knobs. After selecting the correct position,
tighten the locking knobs. The lock knobs are on the right side of the machine.
8. Make sure that the cutting head blades are correct, and that all hex head screws are tightened securely
before use.
9. Keep hands away from the feed rollers and the cutting head.
10. Do not operate the machine when the gear cover is open.
11. Remove adjustment tools and loose items from the machine before operating the machine.
12. Wear a dust mask to reduce the risk of inhaling hazardous dust.
13. Wear hearing protection.
14. The equipment can throw debris into the eyes during operation; causing permanent
damage. Always wear safety glasses that comply with ANSI Standard Z87.1.
220 V~
60 Hz
15 A
3 Hp
3 450 RPM
5 000 RPM
6 3/4"
20"
3/16"
1/8"
Authorized
®
This tool meets
with the Official Standard
Mexican (NOM).
2