Truper CEP-20 Instructivo página 23

NOTE: The lift range is between 0.003" - 0.006" when the roller is raised higher than the table as shown in
Fig. 14.
The Table Rollers of your planer are adjusted for average planing, and are parallel to the table surface. If
you wish to adjust the Table Rollers higher or lower, proceed as follows:
Table
Roller
1. Disconnect the machine from the power supply.
2. Install a ruler across both rollers, loosen the screws
(A) Fig. 15, and turn the eccentric arrows (B) to raise
or lower the rollers on the table. When the desired
height is achieved, tighten the screws (B) as shown in
Fig. 15. The rollers on the opposite side of the table
should be adjusted in the same manner.
NOTE:
1. Make sure that the height of the front and rear rollers
is equal.
2. The table rollers should always be adjusted parallel to
the table
Table extension assembly
The table extension can be mounted to the table as shown in Fig. 16 using the hex head screws and washers
provided.
Adjusting the table extension
Install a board between the table extension and the table as shown in Fig. 16 to verify that the table
extension and table are at the same height.
To adjust the table extension, proceed as follows:
1. Loosen the screws and washers Fig. 17 to
move the table extension to the correct
position, then tighten the screws.
FIG. 17
0.003" - 0.006"
(0.07 mm - 0.15 mm)
FIG. 14
FIG. 16
2. Adjust the front and rear extension of the table
equally.
FIG. 15
A
RULER
TABLE
EXTENSION
B
6