3. Remove all anti-fouling treatments and devices.
Note: The manufacturer will not accept sensors that have been treated with anti-fouling compounds for service
or repair. This includes AF 24173 devices, tri-butyl tin, marine anti-fouling paint, ablative coatings, etc.
4. Use the sensor's original ruggedized shipping case to send the sensor back to the manufacturer.
5. Write the RMA number on the outside of the shipping case and on the packing list.
6. Use 3rd-day air to ship the sensor back to the manufacturer. Do not use ground shipping.
7. The manufacturer will supply all replacement parts and labor and pay to send the sensor back to
the user via 3rd-day air shipping.
4.2 Warranty
Refer to the manufacturer's website for warranty information (seabird.com/warranty).
4.3 AF24173 anti-foulant device
AF24173 Anti-Foulant Devices supplied for user replacement are supplied in polyethylene bags
displaying the following label:
AF24173 ANTI-FOULANT DEVICE
FOR USE ONLY WITH SEA-BIRD ELECTRONICS' CONDUCTIVITY SENSORS TO CONTROL
THE GROWTH OF AQUATIC ORGANISMS WITHIN ELECTRONIC CONDUCTIVITY SENSORS.
ACTIVE INGREDIENT: Bis(tributyltin) oxide . . . . . 52.1%
OTHER INGREDIENTS: . . . . . . . . . . . . . . . . . . . . 47.9%
TOTAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100.0%
DANGER
See Precautionary Statements for additional information.
FIRST AID
If in eyes
If on skin or clothing
If swallowed
8 English
• Hold the eye open and rinse slowly and gently with water for 15–20 minutes.
• Remove contact lenses, if present, after the first 5 minutes, then continue rinsing
eye.
• Call a poison control center or doctor for treatment advice.
• Take off contaminated clothing.
• Rinse skin immediately with plenty of water for 15–20 minutes.
• Call a poison control center or doctor for treatment advice.
• Call poison control center or doctor immediately for treatment advice.
• Have person drink several glasses of water.
• Do not induce vomiting.
• Do not give anything by mouth to an unconscious person.