TOPDON BTMOBILE PRO Manual Del Usuario página 5

APP Installation & Setup
Installation:
Download and install the App: search
"BTMobile Pro" in Apple Store or
Google Play.
NOTE: Compatible with iOS 10.0 /
Android 5.0 smart devices, or newer.
Set up
For the first time, you can choose
to register with email or skip login.
But we strongly recommend the
registration for latest product news
and timely technical assistance.
5
Operation Introduction
Before Test:
1. Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all of the
vehicle's doors and trunk lid.
2. Make sure the battery terminals are clean. Use a wire brush to clean them, if necessary.
NOTE: This tester works best if the battery connectors have been removed and the battery posts have
been cleaned. Any corrosion between the tester clamps and the battery connectors, or between the
battery connectors and the battery posts, will degrade the tester's efficiency.
3. Connect the RED (+) Positive Battery Clamp to the (+) positive battery terminal, and connect the
BLACK (-) Negative Battery Clamp to the (-) negative battery terminal. Ensure that the clamps are
securely attached to the correct terminals.
4. Open the Bluetooth on mobile device or tablet.
5. Test Introduction
• BATTERY TEST: Display SOH (State of Health), SOC (State of Charge), Voltage, Test Value, Internal
Resistance, and the readable analysis results on App;
• CRANKING TEST: Analyze the actual cranking voltage and the cranking time to help you quickly figure
out the whole state of the starting system;
• CHARGING TEST: Test different parts of charging system, including generator, rectifier, rectifier diode,
and so on for a reliable charging volt value.
6