JULIUS MAYER JMHST-5 Manual De Instrucciones página 20

PROGRAMMING
Programming the handheld transmitter – JMHST-5 (Initial programming)
Each keystroke must be executed within 4 seconds!
Otherwise, the system automatically exits the programming mode.
1. First select the desired channel from channels 1 to 5 by pressing the K1 or K2 key (the channel highlighted in black is
selected).
If all channels are highlighted in black, group control is activated!
(all channels are controlled by keystroke or time control).
The group function cannot be taught-in separately as a channel!
2. Then put the receiver (motor/external receiver) into programming mode according to the instructions.
3. Press the P2 programming key (back) 2 times.
4. Press the UP key 1 x.
5. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
OK - programming successfully completed.
6. To program additional receivers/motors, start from the beginning.
*The frequency of the beeps or the response of the motor/roller shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver/motor.
Then check the function by pressing the UP/STOP/DOWN keys.
If the direction of rotation of the motor is reversed (roller shutter/motor moves downwards when the UP key is pressed),
please start from the beginning and press the DOWN key after the P2 key instead of the UP key!
This will change the direction of rotation of the motor.
To program several transmitters/channels for ONE motor/receiver, the „Add handheld transmitter" function must be used
(depending on the receiver model), as - e.g. with radio motors - only one transmitter can be programmed directly into the
receiver. Please observe the corresponding instructions of the respective receiver/motor!
20 20
Display channel display / function display
K1
K2
Up
Stop
Down
P2 key (programming key)