Publicidad
Idiomas disponibles
Idiomas disponibles
Add handheld transmitter
1.
Power is ON (motor is connected and ready for operation).
2.
At an ALREADY PROGRAMMED station, select by pressing the K1 (or K2) button to select an already programmed
channel.
3.
Then, on the station to be programmed NEW, select the channel you want to add by pressing the K1 (or K2) key, you
want to add (the channel highlighted in black is selected).
4.
Press the P2 programming button (back) 2 times on the already programmed handheld transmitter.
5.
Then press the P2 programming button (back) 1 x on the handheld transmitter to be reprogrammed.
6.
The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
7.
OK - Handheld transmitter is added!
Delete handheld transmitter
1.
Power is ON (motor is connected and ready for operation).
2.
Press P2 programming key 1 x. Motor beeps 1 x.
3.
Press STOP key 1 x. Motor beeps 1 x.
4.
Press P2 programming key 1 x. Motor beeps 3 x*.
5.
OK! ALL handheld transmitters are deleted!
*The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver / motor.
Individual deletion of hand-held or wall-mounted transmitters is NOT possible with the receivers!
For further information, please refer to the instructions of the Julius Mayer radio tubular motors or radio receivers.
K1
K2
Up
Stop
Down
PROGRAMMING
P2 key (programming key)
21
21
Publicidad
