ST T 92 Serie Guía Rápida De Uso página 118

Brake engaged.
• Headlight switch (Fig. 15.E)
The button switches the headlights on
when the key is in THE "RUN" position.
• Cutting means engagement and disengagement
control (Fig. 15.F.1 and 15.F.2)
Cutting means engaged.
Cutting means disengaged.
• Button for reverse gear cutting consent (Fig. 15.G)
Press and hold the button to reverse
while the cutting means are engaged,
without causing the engine to stop.
• Controls for adjusting the cutting means assembly
height (Fig. 15.H)
Control with lever: this lever raises and lowers the cutting
means assembly.
The seven positions are indicated
by "1" to "7" on the related plate.
To change positions, press the release
button on the end of the lever.
Control with lever and knob: this lever raises and lowers
the cutting means assembly.
Position "A" = cutting device assembly raised.
Position "B" = cutting device assembly lowered.
The knob (Fig. 15.I) allows the positioning of the cutting
means assembly.
• Speed cruise control
Pressed: device disabled (deactivated)
Pulled: device enabled (active)
• Counter (if equipped) (Fig. 15.K)
• Auxiliary accessory socket
• Grass catcher tipping command
Manual control:
The grass catcher is overturned for emptying by means of
the lever (Fig. 15.L).
Electrical control:
To tip the grass catcher bag in order to empty it, the
operator must press and hold the button (Fig. 15.N) until
the command motor stops running.
The grass catcher is returned to the working position
by pressing and holding the button (Fig. 15.O) until the
retaining catch locks into place and the command motor
stops running.
• Type "I" display and buzzers
Indicator light ON: cutting devices engaged
(Fig. 16.A).
Indicator light ON: parking brake engaged
(Fig. 16.B).
Indicator light ON: operator not present
(Fig. 16.C).
Flashing indicator light: fuel is in reserve
(Fig. 16.D).
Flashing indicator light: engine lubrication
faults (Fig. 16.E). Stop engine immediately,
check oil level and contact an Authorized
Service Centre.
Indicator light ON: grass catcher or rear
discharge guard missing (Fig. 16F).
Indicator light ON: when the engine is running
there are battery re-charging faults (Fig. 16.G).
Flashing indicator light before start-up: the
battery is unable to start the engine. Contact
an Authorized Service Centre (Fig. 16.G).
Indicator light ON: transmission in "neutral"
(Fig. 16.H).
• Acoustic signals - Buzzer
1. Continuous
acoustic signal:
2. Intermittent
acoustic signal:
EN - 5
(Fig. 15.M)
• Electronic card protection
system has intervened.
• The engine has been
switched off for more than
30 seconds with the key
in the "DRIVE" position.
• The grass catcher is full.