Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
TOOL NEEDED
Phillips Screwdriver
UNPACKING
This Product Requires Assembly.
Check all parts from carton against the Carton Contents List.
If any parts are damaged or missing, contact 1-800-4-RIDGID
(US and Canada) or by email at info@ridgidvacs.com.
CARTON CONTENTS LIST (Fig. 1)
Key
Description
A* Detachable Blower .......................................................1
B* Powerhead Assembly ..................................................1
C* Dust Drum Assembly ..................................................1
D* Drain Cap ......................................................................1
E
Caster Foot w/Storage .................................................4
F
Caster ...........................................................................4
G
Pan Head Screw, #10 x 3/4" (19 mm) .......................4
H
Accessory Caddy .........................................................1
I*
Qwik Lock™ Filter .......................................................1
J
Tug-A-Long Positive Locking Hose with Dual-Flex ...1
K
Extension Wands .........................................................2
L
Blower Wand ................................................................1
M
Car Nozzle ....................................................................1
N
Utility Nozzle .................................................................1
O
Wet Nozzle ...................................................................1
P
Owner's Manual ...........................................................1
* These parts come preassembled.
F
G
H
J
SP7037-2 HD16000.indb 4
SP7037-2 HD16000.indb 4
Fig. 1
A*
K
B*
C*
D*
E
N
I*
P
ASSEMBLY
CASTER/CASTER FOOT ASSEMBLY (Fig. 2)
NOTE: Remove Powerhead Assembly from Dust Drum
prior to assembly of Casters and Caster Feet.
1. Place Caster Foot (E) upside down on the floor.
2. Place the Caster (F) into the Caster Foot (E): Insert the
Caster Stem into Caster Foot Socket.
3. Push on the Caster until the Caster Ball end snaps fully
into the Caster Foot Socket and the Caster swivels
freely. Repeat for other Three Casters and Caster Feet.
Qty
4. Turn Dust Drum (C) upside down on floor.
5. Place Caster Foot with Caster over Drum Post and press
firmly in place. Repeat for the other Three Caster/Caster
Foot Assemblies (E & F).
6. Four Screws are available for optional assembly of the
Caster Feet into the Drum. If desired, locate the Four
#10 x 3/4" Pan Head Screws (G) in loose parts bag.
Insert a Screw through the Caster Foot Hole and into
the Dust Drum (C). Tighten securely.
7. Turn the Dust Drum (C) upright.
Caster Stem
(E)
Caster Foot
Socket
Drum Post
L
M
O
4
(F)
(G)
Caster Foot Hole
(C)
1/28/21 1:43 PM
1/28/21 1:43 PM
Fig. 2
Publicidad
