Publicidad
Idiomas disponibles
Idiomas disponibles
SC 35 • Operating Manual
Do not remove protective devices!
• Only operate the machine when all the protective devices fitted in the factory are mounted
and in good working order.
Only use on horizontal surfaces!
• The floor scraper machine must only be used on horizontal surfaces.
• Make sure that the back wheels rest firmly on the surface to be treated.
Do not misuse the electrical power cord!
• Do not use the cable to pull the plug out of the socket.
• Protect the cable against heat, oil and sharp edges.
• Lay the electric cable in such a way that it cannot be damaged by the working tools.
• In the open air, use only specially authorized and suitably marked extension cables.
• Use only electric cables with a suitable cross-section and the necessary length.
• Unroll the extension cable completely from the cable drum.
It is essential that you comply with the Operating Manual of the electric motor manufactur-
er and the following regulations!
• When not in use, make sure that the machine is disconnected from the power supply.
• Modifications to the electrical wiring which may be prejudicial to safety or change the original
regulating and control functions are prohibited.
• Repairs to the electrical wiring may only be performed by a qualified electrician.
Do not remove guard devices!
• Damaged protection devices on machines must be professionally repaired or replaced by a
customer service workshop.
• Operate the machine only if all the guard devices mounted in the factory are in place and in
good working order!
• Do not operate the machine unless the emergency stop switch is in working order.
Operating location and workplace
When working with the machine, the machine operator will always stand behind the handlebar.
From this position, he can permanently monitor and, if necessary, correct the work to be per-
formed. Standing at this position, the machine operator can:
• steer the machine
• hold the machine back
• actuate all the operating and control elements (such as the blade angle adjusting pedal,
emergensy stop) while the machine is in use.
NOTE: Hand-arm vibrations
Working with the SC-25 leads to vibration stressing. Please follow the legal provisions as re-
gards the permitted operating time.
Safety stickers on the machine
Warning: sharp blade
Warning: electric shock hazard
Ear protectors must be worn
Safety instructions
Safety shoes must be worn
Study the Operating Manual
Use protective goggles
7
Publicidad
