VONROC EH512AC Traducción Del Manual Original página 5

3. OPERATING
Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface.
• Keep a minimum distance of 1 m between the
front of the housing and walls and 30 cm from
all other housing surface areas. Keep away from
wet environments.
Warning! Make sure to place the heater in a
safe spot, so you cannot easily trip over the
machine and cable. Make sure to place the
heater where it cannot fall down / of.
Starting the electric heater (Fig. A, B)
• Plug in the cable (11) to the mains.
• Set the thermostat knob (10) to the Max.
• The heater will switch on when the function
knob (9) is set to one of the function settings.
- OFF: Power off
- FAN: Fan only
- HEAT: Low heat – 1200 W
- HOT: High heat – 1800 W
- FAN: Fan with oscillation
- HEAT OSC: Low heat with oscillation
- HOT OSC: High heat with oscillation
• The power indicator light (8) will turn on.
• Once the room reaches the required tempe-
rature, turn the thermostat knob (10) back
slowly until you hear a click and the LED-light
turns off.
• The heater starts and stops automatically to
keep the room temperature constant. Once
the ambient temperature in the room reaches
the desired target temperature, the heating
element will be in standby mode. Once the
ambient temperature starts to decrease, the
heating element will be switched on again.
WWW.VONROC.COM
Tip-over switch (5) (Fig. A)
This heater has a mechanical tip-over protection.
This protection ensures when the heater is not
placed upright on a firm and level surface or when
the heater tip over, the system will automatically
shut the heater off. If this occurs, put the heater on
a firm and level surface and start the heater again.
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
Stopping the electric heater
Let the machine cool down before turning
off by using the ventilation function.
• Turn the thermostat knob (10) to lowest position
and turn the function knob to fan position (9).
• Let the fan cool down the appliance for a few
minutes.
• Turn the function knob (9) to off position.
• Pull the plug out of the mains.
Storing the electric heater
• Always let the heater cool down completely
before storing the machine.
• Never wrap the cable around the heater
Warning! Never store the machine in a wet
or dusty environment
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Cleaning
Let the machine cool down completely
before cleaning.
• Clean the heater with a dry towel or vacuum
cleaner.
• In order to protect the enclosure, don't splash
water onto the heater, and never use a solvent
like gasoline, isoamyl acetate, toluene, etc. to
clean the heater.
• When you store the heater, let it cool down first
and, keep it dry.
EN
5