Andis D-8 Instrucciones De Uso Y Cuidado página 7

immersing the blades only into a shallow pan of Andis Clipper Oil, while the trimmer is running. Any
excess hair and dirt that has accumulated between the blades should come out. After cleaning, turn
your trimmer off, dry the blades with a dry cloth and start clipping or trimming again.
REPLACEMENT (REMOVAL) OF BLADE SET
Your trimmer has a preset tension assembly on the blade set. To remove blade set from your
trimmer, remove from charger base. Turn the trimmer upside down so teeth of blades are facing
down. You may wish to set the trimmer on a flat surface while performing these operations. Using a
phillips type screwdriver, unscrew the two blade screws (Figure L). Remove blade set from trimmer.
Install new blade set, making sure the blade yoke cradles the armature pin on trimmer (Figure M).
There is no need to adjust blade tension before use, as tension has been preset at the factory. Align
screw holes of blade set to screw inserts on trimmer housing. Replace the screws. Before tightening
down blade screws, check alignment of blade set to housing, making sure that they are parallel.
Tighten down screws.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your trimmer does not develop a "memory effect" like a
nickel-metal hydride (NiMH), or nickel cadmium (NiCd) battery. You can return the trimmer to the
charger at any time for a full charge, or even use the battery before a charge cycle is complete.
Like most rechargeable batteries, lithium-ion batteries perform best when used frequently.
2. For maximum battery life, store the trimmer in a partially discharged condition if the unit will be
unused for several months. To discharge the battery, run the trimmer until it automatically shuts
off.
3. Avoid locating the trimmer near heat vents, radiators, or in direct sunlight. Optimum charging
will result where the temperature is stable. Sudden increases in temperature can result in the
battery receiving less than a full charge.
4. Many factors influence lithium-ion battery life. A battery that has received heavy use or is more
than a year old may not give the same run-time performance as a new battery pack.
5. New lithium-ion batteries, unused for a period of time, may not accept a full charge. This is
normal and does not indicate a problem with the battery or charger. The battery will accept a full
charge after several cycles of trimmer use and recharging.
6. Disconnect the charger or the trimmer from the AC outlet if extended periods of non-use are
anticipated.
DISPOSAL OF BATTERY PACKS
As a consumer you are legally obliged to dispose of batteries and battery packs as special waste.
Information regarding how to remove the battery pack from the relevant device at the end of
its life can be found on page 96. After removing the battery pack, the device must be disposed
of and may NOT be used again.
CAREFUL! RISK OF INJURY CAUSED BY DEFECTIVE, LEAKY BATTERY PACK!
The battery pack used contains substances that may cause injury if they come into contact with skin
or are inhaled. If a battery pack has leaked in your device, you may only remove it from the device
while wearing rubber gloves, then it should be placed in a closed container and sent for proper
disposal. In accordance with the European directive 2013/56/EU, defective battery packs/batteries
must be collected separately and sent for environmentally-friendly recycling. The following disposal
options are available: – By way of dealers; – By way of a return station with the GRS symbol; –
By way of community provided special waste collection containers. Other disposal information can
be obtained from your community or city administration.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it is advised to
purchase a new set of blades available through your Andis supplier. Some blade sets can be
resharpened - contact your Andis supplier or the Andis Company for information on resharpening.
If you wish your clipper/trimmer to be serviced as well, contact your Andis supplier. If you have a
problem contacting your Andis supplier contact the Andis Company customer service
department at 1-262-884-2600 or email at info@andisco.com.
7