Publicidad
Idiomas disponibles
Idiomas disponibles
Jandy
TruChlor Erosion Feeder
®
NOTE: For a pool/spa combo with 2" PVC plumbing and equipment, install the feeder
on the pool return line after the diverter valve that diverts water to the spa. Then
install a minimum section of 6" x 1.5" PVC pipe from the diverter valve into
the inlet side of the feeder using 1.5" unions. Continue with 2" PVC pipe on the
outlet side of the feeder. This will compensate for the water being diverted to
the spa.
2. Glue Jandy Universal Unions into 2" or 2 1/2" PVC pipe.
3. When plumbing 90 degree elbows directly into the feeder inlet it may cause
turbulence inside the elbow which prevents water from entering the feeder. A
minimum of 6" PVC pipe should be installed between the elbow and the inlet of the
feeder.
4. Ensure valve nuts are hand tight.
5. The arrows on feeder body should point in the direction of the water flow returning to
the pool.
6. Use only PVC cement. Follow the directions on the cement label. Allow time for the
PVC cement to completely dry.
Figure 4.
In-Line Installation Configuration
Section 4. Off-line Installation
1. Position the dosing unit on a level surface as close to the filter and pump as possible.
Do not install in copper plumbing.
2. The base has holes at bottom for mounting to the pad floor (mounting hardware not
included).
3. Turn off the pump and timer switches.
4. The inlet connection must be made in the pipe-work after the pump and filter. This
connection will feed water into the dosing unit.
|
Installation & Operation Manual
FILTER
PUMP
ENGLISH
RETURN
TO POOL
CHECK VALVE
Page 7
Publicidad
