Publicidad
Idiomas disponibles
Idiomas disponibles
Jandy
TruChlor Erosion Feeder
®
a. Thread on one ½" socket nut to the feeder inlet barb and another to the outlet barb
of the feeder. Be sure an o-ring is seated in the groove inside each socket nut.
b. Insert plumbing nipples into the plumbing clamps and secure with the remaining
½" socket nuts. Be sure an o-ring is seated in the groove inside each socket nut.
c. Drill 3/4" hole in plumbing and remove any burrs.
d. Install clamp assembly over the plumbing where the 3/4" hole was drilled
(Figure 7).
e. Use ½" Sch 40 PVC pipe and fittings to connect the ½" socket nuts at the plumbing
to the ½" socket nuts at the inlet and outlet.
Figure 6.
Connecting Hardware to Feeder
Figure 7.
Connecting Hardware To Pipe
|
Installation & Operation Manual
Plumbing
Nipple
Assembled Plumbing
Adapter
ENGLISH
1/2in Socket
Nut with
O-Ring (for hard pipe)
Compression
Compression
Nut
Cone
Compression
Cone
Compression Nut
1/2in Socket Nut
1/2in PVC
Page 9
Flex
Tubing
Tubing
To Feeder
Publicidad
