Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING, OR WHILE CONNECTED
TO A POWER SOURCE.
Special Safety Regulations (cont.)
-
Do not place the appliance on moving vehicles or
somewhere it may easily tip over.
-
Use the appliance in places with good air
ventilation, do not position it near a wall or corner.
-
It is recommended that a separate circuit serving
only this appliance be provided. Keep the power
cable far enough from the hot air outlet.
-
If the supply cable is damaged, it must be replaced
by the manufacturer or service agent or a similarly
qualified person in order to avoid a hazard.
-
You must not connect other appliances to the
same electrical outlet as the fan heater.
-
Do not dispose of electrical appliances as unsorted
municipal waste; use separate collection facilities.
Contact your local government for information
regarding the collection systems available. If
electrical appliances are disposed of in landfills or
dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being. When replacing old
appliances with new ones, the retailer is legally
obligated to take back your old appliance for
disposals free of charge.
-
If the fan heater is to be permanently installed, the
following instructions must be observed (see figure
2).
Figure 2. Installing your Heater
Operation
-
Position the fan heater so that it stands upright on a
-
Connect the fan heater to the electrical power.
-
Set the thermostat dial to the maximum
-
The fan heater will switch on when the function
-
Once the room reaches the desired temperature,
Cleaning and Maintenance
-
Before cleaning the appliance, disconnect it from
-
The enclosure is easy to get dirty. Wipe it often
- In order to protect the enclosure, don't splash
- Clean the coupler, dry and pack it in a plastic bag.
- When you store the heater, let it cool down first
Electric Fan Heater User's Manual
firm surface and at a safe distance from wet
environments and flammable objects.
temperature.
selector dial is set to one of the three power
settings.
turn the thermostat dial back until heating element
turns off. The fan will still continue to run. The
thermostat is now set at your desired temperature,
and the heater will continue to maintain a constant
temperature.
the outlet and let it cool down.
with a soft sponge. For very dirty parts, wipe with a
sponge dipped in < 50°C water and mild detergent,
then dry the heater enclosure with a clean cloth.
Be careful not to let the water enter the inside of
the appliance
water onto the heater, and never use a solvent like
gasoline, isoamyl acetate, toluene, etc. to clean
the heater.
and, keep it dry. Then cover it with a plastic bag,
put it in the packing box and store it in a dry,
ventilated place.
Electric Fan Heater
Page 3
EN
Publicidad
