Manuales relacionados para Sanus VLF628
Resumen de contenidos para Sanus VLF628
- Página 1 GET IT RIGHT THE FIRST TIME Follow this step-by-step VLF 628 instruction manual to speed up your installation. INSTRUCTION MANUAL...
- Página 2 Our US-based install experts shows how easy this DIY HeightFinder™ shows you are standing by to help. project will be? where to drill. Call us at: 800-359-5520 Watch it now at: Check it out at: SANUS.com/2556 SANUS.com/1172 Or, chat at: SANUS.com/chatSP...
- Página 3 Does your TV No — Perfect! (including accessories) 150 lbs. weigh MORE than Yes — This mount is NOT compatible. Visit MountFinder.Sanus.com or call (68.0 kg) 150 lbs. (68.0 kg)? 1-800-359-5520 (UK: 0800-056-2853) to fi nd a compatible mount. What is your...
- Página 4 Before you begin Don’t stress out Remove the stand Install any accessories when you see from your TV — if attached. you may have purchased — if they all the hardware included. require the TV to be removed from the Extra TV screw sizes and lengths wall for assembly.
- Página 5 Step-by-Step illustrations Read ALL CAUTION Protect the face warnings. of your TV speed up your installation. when laying it down for installation. These are IMPORTANT! Don’t get it? Read the detailed explanation below each step. CAUTION: ASSEMBLE Avoid potential Soft clean surface Read Important Stuff read read rea Must Read read read read read read Read read read Safety First read re...
- Página 6 STEP 1 Attach TV Bracket to TV WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Página 7 1.1 Select TV Screws 1.2 Spacer Determination TV Bracket TV Bracket Flat Back Cable Interference Round Back Inset Holes TV Bracket TV Bracket TV Bracket Too Short Correct Too Long For flat-back TVs: For rounded-back TVs, cable interference or inset CAUTION: holes: use spacers Verify adequate thread engagement with your...
- Página 8 1.3 Assemble TV Bracket LOOSEN ADJUST TO FIT TV Adjust TV bracket to line up with your TV's mounting hole pattern. Loosen the upper two and lower two fasteners enough to slide the outer columns on TV bracket . (Indicated with arrows).
- Página 9 CENTER TIGHTEN CAUTION: Avoid potential personal injury or property damage! Do not overtighten the fasteners. Tighten only until snug. Be sure the center column is evenly spaced between the outer columns. Tighten the upper and lower fasteners and verify the center fasteners are also tightened.
- Página 10 1.4 Attach TV Bracket Assembly to TV POSITION SECURELY TIGHTEN f T V T o p o Rounded-back TVs / Extra Space Flat-back TVs 11 12 13 Center TV bracket over your TV hole pattern as shown, making Install using the spacer, screw and washer combination you selected for your TV.
- Página 11 STEP 2 Attach Wall Plate to Wall WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Página 12 STEP 2A Wood Stud Installation CAUTION: Avoid potential Min. 1 ½ in. (3.8 cm) personal injury or property damage! ● Drywall covering the wall Min. 16 in. (40.6 cm) Min. 3 ½ in. (8.9 cm) must not exceed 5/8 in. (1.5 cm) ●...
- Página 13 /1172 To calculate your precise wall plate location, check out TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Pull out one end of each wall plate cover and remove (to expose Place the wall plate template at your desired height and position the mounting holes).
- Página 14 STEP 2A (continued) DRILL SECURELY TIGHTEN 3 ½ in. (8.9 cm) washers MUST be installed in TOP positions 7/32 in. (5.5 mm) CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate .
- Página 15 STEP 2B Solid Concrete or Concrete Block Installation CAUTION: REMOVE Avoid potential personal injury or property damage! ● Mount the wall plate directly onto the concrete surface ● Minimum solid concrete thickness: 8 in. (20.3 cm) ● Minimum concrete block size: 8 x 8 x 16 in. (20.3 x 20.3 x 40.6 cm) ●...
- Página 16 TIP: Never drill into the mortar between blocks. Never drill into the mortar between blocks. our HeightFinder at sanus.com [www.sanus.com/1172]. Position the wall plate template on the wall at your desired height. Drill four pilot holes using a 3/8 in. (10 mm) diameter drill bit.
- Página 17 INSERT SECURELY TIGHTEN washers MUST be installed in TOP positions CAUTION: Avoid potential personal injury or property damage! All four lag bolts MUST BE firmly tightened to prevent Be sure the anchors are seated fl ush unwanted movement of the wall plate .
- Página 18 STEP 3 Attach TV to Wall Plate WARNING: Before starting assembly, verify this part is undamaged. If damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! Parts and Hardware for STEP 3 Hex Key 3/16 in.
- Página 19 3.1 Attach Arm Assembly to Wall Plate HANG HEAVY! You may need assistance with this step. CAUTION: Avoid potential personal injury or property damage! For CONCRETE APPLICATIONS: The arm assembly MUST remain centered in wall plate NOTE: For WOOD STUD APPLICATIONS, the arm assembly Hang the top hook of arm assembly , onto wall plate ,Then...
- Página 20 3.1 (continued) SECURE INSERT CAUTION: Avoid potential personal injury or property damage! Always make sure both locking screws are tightened, so the arm assembly is securely fastened to wall plate Secure arm assembly onto wall plate using two locking Insert one end of each wall plate cover then slightly bow the middle to insert the other end in place.
- Página 21 3.2 Hang TV onto Arm Assembly HANG POSITION HEAVY! You may need assistance with this step. To make it easier to hang the TV, position the arm assembly Hang the TV onto the arm assembly by hooking the top support so one elbow is pressed against the wall.
- Página 22 3.2 (continued) ATTACH SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! Always make sure your locking screw is tightened, so the TV is securely fastened to the arm assembly Press the bottom of the TV into the arm assembly until you hear the , tighten the locking screw K To lock the TV in place on arm assembly...
- Página 23 Manage Cables TIP: TIP: REMEMBER which cover came off of which arm (for reattaching). NOTE: Pull each arm to its full extension, to leave enough slack and prevent stretching the cables when the arms are moved. Remove the cable covers C from the arms and route the cables along the arms.
- Página 24 Adjustments LEVEL Loosen both leveling screws Level your TV. (If needed, loosen secondary screws FINGER TIGHTEN both leveling screws Securely tighten both leveling screws to prevent unwanted TV movement. CAUTION : Avoid potential injuries or property damage! Do NOT overtighten the screws.
- Página 25 TILT Your TV should adjust easily when moved, then stay in place. Adjust the tilt tension knobs if your TV naturally tilts up or down. NOTE: If you do not intend to adjust the tilt for different viewing locations, you can tighten the tilt tension knobs by hand, to prevent unwanted movement.
- Página 26 TV LATERAL SHIFT HEAVY ! You may need assistance with this step. CAUTION : Avoid potential injuries or property damage! Do NOT adjust the arm position from center for concrete applications. MUST remain centered in wall plate for all concrete applications! For wood stud applications ONLY: Remove the TV (See PAGE 27).
- Página 27 REMOVE THE TV REMOVE THE ARM ASSEMBLY HEAVY ! You may need assistance with this step. Disconnect all cables from the TV. Loosen the locking screw using hex key Pull down on the Release ring to release the TV. Carefully lift the TV from arm assembly...
- Página 28 Troubleshooting If you are uncertain about your hardware selection, contact Customer Service at 1-800-359-5520 TV Supplied TV supplied spacers Spacers : Use your TV supplied spacer for flat back TVs : Use your TV supplied spacer and spacer (AND you want for: your TV closer to the wall).
- Página 29 Dimensions in. [mm] TV INTERFACE 23.62 600.0 3.94 100.0 16.54 420.0 WALL PLATE TOP VIEW - EXTENDED SIDE VIEW - EXTENDED 30.50 0.36 774.7 4° 15° 11.72 14.91 297.8 378.6 30.00° 30.00° 16.00 406.4 17.72 450.0 23.62 ESTIMATED 65" TV 600.0 28.00 24.00...
- Página 30 ¿Su televisor No. ¡Perfecto! (incluidos los 34,0 kg accesorios) Sí. Este soporte NO es compatible. Visite MountFinder.Sanus.com o llame al 1-800-359-5520 (75 lb) pesa MÁS de (Reino Unido: 0800-056-2853) para encontrar un soporte compatible. 34,0 kg (75 lb)? ¿De qué está...
- Página 31 Español ¡ESTAMOS AQUÍ PARA AYUDARLE! ¿Desea ver un video para comprobar lo fácil que es hacerlo usted mismo? SANUS.com/2556 Visualícelo ahora en: Acierte a la primera. HeightFinder™ le indica el lugar donde debe taladrar. SANUS.com/1172 Descúbralo en: Nuestros expertos en instalación de EE. UU. están listos para ayudar.
- Página 32 Español 1.1 Seleccione los tornillos del televisor PRECAUCIÓN: Compruebe el enrosque adecuado de la combinación tornillo/arandela/espaciador y los soportes del televisor. (PASO 1.3). Si el tornillo es DEMASIADO CORTO, no sostendrá el televisor. Si es DEMASIADO LARGO, el televisor se dañará. Determine qué...
- Página 33 COLOCAR LA PLANTILLA DE LA PLACA MURAL CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.sanus.com/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios.
- Página 34 COLOCAR LA PLANTILLA DE LA PLACA MURAL CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta Height Finder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural en la pared a la altura que desee. Nivele y marque la ubicación de los orificios.
- Página 35 Español PASO 3 Fijar el televisor en la placa mural PÁGINA 18 ADVERTENCIA: Antes de empezar el montaje, compruebe que esta parte no esté dañada. Si lo está, no la devuelva al distribuidor. Póngase en contacto con el servicio de atención al cliente.
- Página 36 Español Organizar los cables PÁGINA 23 CONSEJO: RECUERDE de qué brazo procede cada cubierta (para volverlo a colocar). NOTA: Extienda completamente cada brazo para dejar suficiente holgura y así evitar tirar de los cables al mover los brazos. Retire las cubiertas para cables C de los brazos y coloque los cables a lo largo de los brazos.
- Página 37 Español Solución de problemas PÁGINA 28 Use el separador proporcionado para televisores con partes traseras planas (o bien si quiere que su televisor esté más cerca de la pared). Use el separador proporcionado con el televisor y el separador para: televisores con la parte trasera redondeada (irregular) o si necesita espacio adicional para los cables.
- Página 38 Milestone AV Technologies and its affi liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product.
- Página 39 Register your new mount and tell us how you like it for a chance to win in our monthly sweepstakes. Entering is quick and easy. Visit SANUS.com/1234 and follow three simple steps for your chance to win. "Monthly Prize" sweepstakes rules and restrictions apply. Visit...
- Página 40 800-359-5520 • info@sanus.com • SANUS.com SANUS • 6436 City West Parkway • Eden Prarie, MN 55344 USA ©2016 Milestone AV Technologies. All rights reserved. SANUS is a division of Milestone. 6901-002615 00 All other brand names or marks are used for identification purposes and are trademarks of their respective owners.