Publicidad
Idiomas disponibles
Idiomas disponibles
▶ If the battery is too hot to touch, it may be defective. Put the battery
in a place where it is clearly visible and where there is no risk of fire,
at an adequate distance from flammable materials. Allow the battery
to cool down. If it is still too hot to touch after an hour, the battery is
faulty. Consult Hilti Service or read the document entitled "Instructions
on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage
and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries
that you can access by scanning the QR code at the end of these
operating instructions.
3
Description
3.1 Product overview
Battery
@
Battery status indicator
;
Battery release button
=
Charger operating status indi-
%
cator
3.2 Intended use
The product described is a portable battery charger for Hilti Li-ion batteries
with a rated voltage of 21.6 volts. It is designed to be connected to power
outlets providing an AC (alternating current) voltage of 100 to 127 volts or
220 to 240 volts (depending on country-specific version).
A list of the Hilti Li-ion batteries approved for use with this product can
•
be found at the end of these operating instructions.
•
Not all batteries are available in all markets.
3.3 Operating status indicator of the charger
Status
LED shows green.
LED doesn't light.
3.4 Status indicators of the Li-ion battery during charging
When a Hilti Nuron Li-ion battery is connected to a Hilti charger, the status
indicator of the battery shows the state of charge and also fault messages,
if applicable.
*2275225*
1
&
(
)
Meaning
Charger is ready for use.
Charger is not ready for use.
2275225
Air exit
Air intake
Battery interface
English
5
Publicidad
