Publicidad
Idiomas disponibles
Idiomas disponibles
Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 5.
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 3. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly. (Fig. 6)
Step 4. Route wires exiting from the top of the fan
motor through the coupling cover, canopy cover,
canopy and then through the downrod. (Fig. 7)
WARNING
FAILURE TO PROPERLY INSTALL
LOCK PIN AS NOTED IN STEP 5
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 5. Carefully insert the hanger pin through
the holes in the collar and downrod. Be careful
not to jam the pin against the wiring inside the
downrod. Insert the lock pin through the hole near
the end of the hanger pin until it snaps into its
locked position, and tighten set screws as shown
in Figure 8.
Ceiling hanger
bracket
Figure 5
120V wires
Lock pin
Set screw
Figure 6
Canopy
Canopy cover
Fan motor
Coupling cover
assembly
Figure 7
UL Listed
electrical box
Washers
Mounting screws
(supplied with
electrical box)
Figure 8
Hanger
pin
Figure 9
Step 6. Cut off excess fixture wires leaving
approximately 6 to 9 inches above top of hanger
ball/downrod assembly. (Figure 9)
6 to 9in
4.
Publicidad
