Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 15

Inserting the Bluetooth
Connectivity Tool Module
(GWS18V-13C)
Read the corresponding operating instructions
for information about the Bluetooth® Connectiv-
ity Tool Module.
Vibration Control Side Handle
The side handle is used to control and balance
the tool. The handle must be thread ed into the
front housing on either side of the tool, depend-
ing on per sonal preference and comfort. Use the
side handle for safe control and ease of opera-
tion (Fig. 1, 2).
Hand Shield (sold separately)
The hand guard is to be used with backing pads,
sanding discs and wire brushes to keep fingers
and hand away from work surface, sharp edges,
burrs and debris. When using the optional hand
guard accessory insert side handle through hole
in guard and then thread into housing (Fig. 1, 2).
Ensure that hand guard is positioned between
hand and backing pad, sanding disc or wire
brush.
Quick-Clamping Nut
Only use accessories with
Maximum Safe Operating
Speed rated at least equal to the maximum
speed marked on the power tool. This speed is
based on the strength of the wheel. It is not
meant to imply a best or most efficient operating
speed. Do not exceed the Maximum Safe Oper-
ating Speed.
Use the quick-clamping nut to secure the grind-
ing/cutting disc without the need for additional
tools. Only use the quick-clamping nut for grind-
ing/cutting discs up to a maximum diameter of
6".
160992A7PL GWS18V-13CP 202206.indd 15
Assembly
• The quick-clamping nut may be used only for
grinding or cutting discs.
• Only use quick-clamping nuts that are in
good working order and not damaged.
• When screwing on, make sure that the print-
ed side of the quick-clamping nut is not fac-
ing the grinding disc.
Press the
lock button to lock
the grinding spindle.
To tighten the quick-
clamping nut, lift the
fold-up bar and turn
the quick-clamping nut
firmly clockwise. Then
push down the fold-up
bar to secure the quick-
clamping nut. It is not
sufficient to tighten the
disc along the edge.
A properly
undamaged
clamping nut can be
removed by hand. To
do this, lift the fold-up
bar and turn the quick-
clamping nut
anticlockwise, Fig 8.
If the quick-clamping
nut is stuck, do not at-
tempt to loosen it with
a tool – always use a
two pin spanner.
-15-
spindle
secured,
quick-
firmly
6/22/22 2:39 PM